investlat.blogg.se - Using smart phone flash tool in uart mode

#USING SMART PHONE FLASH TOOL IN UART MODE ZIP FILE#
#USING SMART PHONE FLASH TOOL IN UART MODE DRIVER#

If the user does not have administrator privileges, a user id and password with these privileges must be entered to continue. If the user has administrator privileges, click on the "yes" button to continue installation. A "User Access Control" dialog will appear when starting the installer.

#USING SMART PHONE FLASH TOOL IN UART MODE DRIVER#

The installation of SmartRF Flash Programmer must be executed with administrator privileges to allow USB driver installation. Run the set-up file and follow the instructions.Read the manifest file for information about the release.

#USING SMART PHONE FLASH TOOL IN UART MODE ZIP FILE#

Download the ZIP file to your hard drive.

SmartRF Flash Programmer and SmartRF Flash Programmer 2 run on 32 and 64-bit versions of Microsoft® Windows 7 and Windows 10.

Read/Write MAC (IEEE EUI64/48/BLE) addresses.

Verify software image on device against file.

Read out software image from device into binary, hex or ELF files (elf and bin for ARM-devices only).

Append software image to existing software on device.

Programming/updating firmware and bootloader on the Evaluation Boards' USB MCU.

Programming of SW images on low-power RF wireless MCUs.